40th International Conference on Production Engineering of Serbia
ICPES 2025
Nis, Serbia, 18-19th september 2025
MEASUREMENT OF NOISE AND VIBRATION IN THE CUTTING ZONE DURING TURNING
Zvonko Petrovic, Branko Radicevic, Bogdan Nedic, Radovan Nikolic
DOI: 10.46793/ICPES25.462P
Turning is a complex machining process due to the influence of numerous factors and is accompanied by the occurrence of noise as well as forced and self-excited vibrations. Measuring these quantities enables more accurate modeling of the cutting process and the determination of optimal machining conditions. In this study, sound energy and vibrations during the turning process were measured, and the measurement methodology was described. The selected input machining parameters were: cutting speed (v), depth of cut (a), and feed rate (s). Optimal machining conditions were then determined using the Particle Swarm Optimization (PSO) method
Noise, Vibrations, Particle Swarm Optimization (PSO)
[1] D. Makarov: Optimization of the cutting process, Technologist's Library, Moscow, 1976.
[2] V.R. Milacic: Forced and self-excited vibrations of machine tools, Proceedings of the Fifth Conference on Production Engineering, 15-16. V 1969, Kragujevac, pp. AM1.1-AM1.14.
[3] Tobias S.A.: Machine Tool Vibration, Blackie, (1965).
[4] Tlusty, J.: Selbsterregte Schwingungen an Werkzeugmaschinen, VEB Verlag Technik, (1962).
[5] Kudinov, V.A.:Dynamics of Machine Tools*. Mir Publishers, (1968).
[6] M. Zaric: Modeling of the turning process of heat-treated steel, PhD thesis, Faculty of Technical Sciences Novi Sad, Novi Sad, Srbija, 2018.
[7] Košarac A., Željkovic M., Mladenovic C., Živkovic A.: Identification of self-excited vibrations during turning using modern diagnostic equipment, IMK-14 – Research and Development in Heavy Machinery Engineering, pp.SR105-SR111 (2013).
[8] Peklenik, J., Gartner, J.: Workpiece Accuracy Criterion for the Dynamic Machine Tool Acceptance Test, MTDR, (1966) .